The National Transportation Safety Board (NTSB) says the veteran pilot had a hand in the fatal hot air balloon accident last October in New Mexico. The investigation was hampered by the pilot's lack of cooperation with NTSB investigators and the fatal accident has spawned several lawsuits against the pilot...
For immediate service; more information; and multi-user access (site license), non-profit organization, educational institute pricing, contact Karen Garner kgarner@accessintel.com at (301) 354-1612.
This story is only available to paid subscribers. Please login below with your username and password if you are a subscriber.
Subscribe Trial
The National Transportation Safety Board (NTSB) says the veteran pilot had a hand in the fatal hot air balloon accident last October in New Mexico.
The investigation was hampered by the pilot's lack of cooperation with NTSB investigators and the fatal accident has spawned several lawsuits against the pilot (who died in March) and his employer.
On October 8, 2007, an Aerostar S-66A (N7179Z) registered to Star Trail and piloted by a commercial pilot, was substantially damaged when it became entangled in power lines shortly after taking off at Albuquerque, NM. One passenger was killed and two passengers were seriously injured. The pilot and one passenger were uninjured.
The pilot was asked by the NTSB to provide details on the fatal accident, but he did not respond and failed to return telephone calls from both the NTSB and the FAA.
Safety Board investigators had to turn to a New Mexico State Police report, an FAA report, and interviews with other pilots and with witnesses to complete their accident investigation. Seeking additional information, an FAA inspector was unable to contact the pilot who "had dropped from sight. Even his own family does not know where he is!"
The hot air free balloon was participating in the Albuquerque International Balloon Fiesta.
A witness said wind velocity had increased, and he watched several balloons go by "at high speed and low altitude." The pilot told an FAA inspector that he had been flying in a southwest direction (state troopers determined the balloon had been flying in a southeast direction) and that he had "stayed low to [keep] right of the congested areas" (two of his passengers told state troopers that they were flying "too low").
The NTSB report said the pilot became distracted when he saw another balloon hit a house. The next thing he realized was that the wind had forced the balloon into power lines (he told state troopers that he saw the power lines and activated the burners in an attempt to fly over them. The FAA report indicated that the pilot was on a landing approach and was in visual contact with the power line. As the balloon got closer, it encountered a downdraft and the pilot activated the burners but was unable to clear the power lines).
The balloon's basket struck the top static line of a 3-phase high voltage transmission line. Witnesses said the wind began collapsing the envelope and the pilot activated the burners in an attempt to maintain inflation and break loose from the power line. The basket slid down the wire and the wire became entangled in the basket's skid plate. The pilot then threw a drop line to his chase crew in hopes they could pull him free. This attempt failed. The chase crew then attached the drop line to a pickup truck and tried to tow the balloon free. This attempt also failed. The FAA report said, "The wire cut through the wicker gondola and became entangled with the handle on one of the fuel tanks."
Video footage taken by witnesses showed the braided static wire sawing through the wicker basket. The FAA report continued, "The combined force of the truck and balloon lift, pulled the fuel tank through the wicker gondola creating a large hole." The balloon finally came loose from the power line and started to rise. The drop line broke and the balloon "shot up in the air like a rocket."
Witnesses saw a propane tank fall from the basket, and then saw a passenger fall out. Estimates of the balloon's altitude varied from 70 to 200 feet.
The pilot felt one corner of the basket drop and saw the hole. He looked up through the balloon's throat and could see blue sky because the dilation vent had become unseated.
He did not know he had lost a passenger until the other passengers started yelling, "She fell out! She fell out!"
The balloon drifted east, and then descended. The pilot said the balloon came down faster than terminal descent speed. It landed hard at the intersection of Comanche Road and Vassar Road. Passerby tended to the pilot and passengers until emergency personnel arrived.
The FAA inspector examined the balloon and basket and noted several discrepancies, to wit: (1) the installed propane tanks bore serial numbers different than the ones listed in the aircraft maintenance records; (2) the drop line had been improperly installed.
Another FAA inspector, with the assistance of an Aerostar representative, later measured the deflation strap (p/n 52264-05) and found it to be 116 feet, 2 inches in length, about 10 feet shorter than specifications (126 feet). A photograph taken by a witness while the balloon was still entangled with the power line showed little slack in the deflation strap. The inspector wrote, "This could account for the inadvertent opening of the deflation port [on top] of the envelope when the balloon was suddenly released after the drop line failed. The envelope . . . experienced major contortions and grew in length beyond the normal operating parameters."
FAA's review of annual inspection criteria for the deflation strap was to check only for "abrasions, cuts, burns, and routing." There were no entries of repairs to, or replacement of, the deflation strap. At the request of FAA, Aerostar tested the drop line. It failed at 4,450 pounds. The break occurred in the stitching used to form a loop at one end, but not in the parent material itself.
Print This Page
Email This Page
Archives
Copyright Permissions
